|
#1
|
|||
|
|||
Quite slow !
i'm on a d24 NA wich i'm going to present you soon. i 've dismantled the pistons / conrods assembly, cleaned up and as soon i v'e finished the D24 NA i will lighten the rods and touch up the pistons. i've retouched the head (combustion side) i will show very soon too. Thanks for your interest !
__________________
[SIGPIC][/SIGPIC] |
#2
|
|||
|
|||
I agree with this guy ^^^
|
#3
|
|||
|
|||
Here is a bit of what i did to the head after the ports job.
I broke the sharp angle in the inside valve perimeter to alow more flow at the intake and exhaust strokes. I didn't touch the exterior perimeter part because sharp angles here helps a lot to share turbulences during compression and give a better mix between fuel and air. a before and after shot : pistons will come next
__________________
[SIGPIC][/SIGPIC] |
#4
|
|||
|
|||
Quote:
What are you planning to do to lighten the rods? I suppose the idea is to remove some material from each one? Are you planning on balancing the entire rotating assembly? Excellent work, and thank you for sharing. I saw a few of your videos on Youtube, well done.
__________________
Jim 1985 Volvo 740 GLE turbo diesel |
#5
|
|||
|
|||
Quote:
I try to share because those engines are so cool and not enough loved it motivate too ! About the conrods : i will remove material from the cap and from the pin bushing part (i don't know the name) But i will make the oil reserve bigger first and remove aroud. i will try to soften or remove the typical vein of the forging process and a bit of polishing. i will balance all of them of course and give them the same weight I don't know if the machine shop in town make the dynamic balancing i will have to see that following the wallet capabilities.... a set of main bearings is 250 euros yet + condors bearings 150 euros +gaskets etc.... i need a bore gauge to see if the block is really still good first
__________________
[SIGPIC][/SIGPIC] |
#6
|
|||
|
|||
Funy, old post, but a frenchman as I am, and your pseudo have some parts of my name and surname ;-)
|
|
|