D24T.com  

Go Back   D24T.com > Technical Discussion Area > Body and Interior
Register FAQ Community Calendar Today's Posts Search

Reply
 
Thread Tools Display Modes
  #1  
Old 02-14-2011, 06:34 AM
Zoupop Zoupop is offline
Junior Member
 
Join Date: Oct 2010
Posts: 16
Default 740 1985 tail light

hi,
I want to change my tail light on my 740 but I want to install the 90-92 tail light.
Here is the question: Does the 90-92 tail light fit on my 85??

thank
Reply With Quote
  #2  
Old 02-25-2011, 11:07 AM
Aidan Aidan is offline
Member
 
Join Date: Dec 2010
Posts: 54
Default

not sure if yours is a saloon (sedan) or estate (wagon), (is the 90/92 a 740 or 940?) but if it helps, the tail lights on my '89 740 wagon interchange perfectly with my '95 940 wagon. If their both 740's there should be no reason why they wont fit
Reply With Quote
  #3  
Old 03-01-2011, 12:54 AM
v8volvo v8volvo is offline
Supporting Member
 
Join Date: Jun 2009
Location: Montana, USA
Vehicle: '86 745, '83 764
Posts: 1,657
Default

Haven't done it myself so cannot say firsthand that they are a bolt-in, but I have seen it done so answer is yes, to my knowledge.

Assume you are talking about a sedan -- wagons are the same all the way from 1985 to 1999.
__________________
86 745 D24T/ZF 345k lifted 2.5"
83 764 D24T/M46 155k
Reply With Quote
  #4  
Old 03-02-2011, 07:14 AM
Zoupop Zoupop is offline
Junior Member
 
Join Date: Oct 2010
Posts: 16
Default

yes i'm talking about a sedan
Reply With Quote
  #5  
Old 05-06-2011, 04:54 AM
ian2000t ian2000t is offline
Senior Member
 
Join Date: Feb 2011
Location: West Mids, UK
Posts: 226
Default

Yes it is possible.

I took a pair of '91 740 SE rear lamps and put them on my '88 740 GLE saloon.

The wiring was all different colours so took a bit of poking with a multi-meter to find out which wire to connect to which as they have different connectors (so make sure you get the connector with the new lights).

Also, there is a bit of metal that needs removing from the rear panel. basically an upright strip of metal between the 2 sets of bulbs in the old one - this will foul the new ones. I just chopped it off with angle grinder (cover your paintwork though... i forgot and had rusty metal flecks in the paint after that).

Also, the bit of metal you chop out will have the earth point in it, so don't forget to create a new one. I took the paint off surrounding one of the bolt holes for the lamps and put the ring connector under that.
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -8. The time now is 04:03 PM.


Powered by vBulletin® Version 3.8.10
Copyright ©2000 - 2024, vBulletin Solutions, Inc.