D24T.com  

Go Back   D24T.com > Technical Discussion Area > Diesel Engine and Drivetrain
Register FAQ Community Calendar Today's Posts Search

Reply
 
Thread Tools Display Modes
  #1  
Old 12-21-2023, 10:19 AM
spaceway spaceway is offline
Junior Member
 
Join Date: Dec 2023
Location: Boston
Vehicle: 1989 VW LT , 1983 Volvo Diesel
Posts: 3
Default NA pump with Tdic

Hey i have a problem with my friend 945 tdic.
The problem is that the engine "hooks" on my rpm. So when i go over 2000rpm my engine slooooowly revs down. Right when it goes under 2000 i falls down to idle just like i should. Any ideas? And why i am making this post is cause i wonder if it would work with a NA pump instead of turbo. Any ideas?
Reply With Quote
  #2  
Old 12-21-2023, 12:23 PM
ngoma ngoma is offline
Supporting Member
 
Join Date: Nov 2009
Posts: 1,393
Default

Hard to say with so little information given.

When did the problem start?

Was there anything done to the IP that may have caused this problem?

Were there any adjustments to the fuel (smoke) screw?

Was this run on vegetable oil?

The more info you can provide, the better we can help.

a NA IP on a turbo engine can run, but there will be excessive overfueling at non-boost conditions as it lacks the LDI to reduce overfueling at non- or low-boost conditions.
__________________
1985 744 gle d24t
1985 745 gle d24t
Reply With Quote
  #3  
Old 01-17-2024, 11:28 AM
v8volvo v8volvo is offline
Supporting Member
 
Join Date: Jun 2009
Location: Montana, USA
Vehicle: '86 745, '83 764
Posts: 1,657
Default

It sounds like the smoke screw is turned in too far. RPM hang / delayed return to idle is a common effect of that.

Could also be sticky action in the governor inside the pump, if the issue started unexpectedly and/or after the car sat a long time. That would be scary if so, since it could stick at higher RPMs too and lead to a runaway condition. This might be able to be cured by some of the flush products on the market -- Diesel Purge being a well known one. Many of us have even had good luck flushing with ATF. But you would want to be sure of this as the cause before going down that road, not just try it.

Refer to ngoma's questions -- we would need more background info to be able to give good answers.

NA pump installed on a turbo engine would certainly run the engine just fine, all else equal (that is, assuming a good pump that was installed and timed correctly, and no other underlying engine or fuel system problems). BUT the NA pump does not have the turbo pump's enrichment aneroid system that increases fuel injected quantity in response to boost pressure. So although the engine would run fine, it would perform like a naturally aspirated engine, not taking advantage of the extra power potential of the turbo. In short, not a great idea unless one is truly desperate and has no other option, as it would bring a major sacrifice in performance and driveability.
__________________
86 745 D24T/ZF 345k lifted 2.5"
83 764 D24T/M46 155k
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -8. The time now is 04:13 PM.


Powered by vBulletin® Version 3.8.10
Copyright ©2000 - 2024, vBulletin Solutions, Inc.