Boost Controller Installation ...(Not more than 1 Bar)

[sonny]

Hi

Please look at this Picture



Which one of this Hoses (smaller or bigger diameter) cames the T Piece with the Boost Controller ...

Reason of my question is, i had installed it on the Hose with bigger Diameter on Turbo...
BUT: If i open the boost Controller 90% (that means the same as i Cut of the Pipe), The Turbo Pressure maximum is 1,0 Bar ...

Normally the Turbo musst Press till the engine explodes (Don´t worry, just want to test it)

The "Dump VALVE" at the front of the Inlet manyfold doesn´t exist anymore (Replaced it with a Plumb Rubber Cap...)

I think there is no lost of pressure...

When i had installed the Boost Controller right (I think it is, when i close the controller- Stock setup, the TurboCharger presses 0,7 Bar- which means Factory default...) does anybody know what the Thinner Hose at the Wastegate (Turbo) is for ?

Greetings


Connected So: - on the Bigger Hose. The smaller Hose was untouched.