#21
|
|||
|
|||
The oil feed for the cylinder head is located around the cylinder head bolt on the injection pump side between cylinders 3 and 4. Or right behind the vacuum pump.
There is several drains, but I would highly doubt those would cause an oil leak.
__________________
12mm pump heads, ARP stud kits and GTD nozzles available! http://d24t.com/showthread.php?t=1646 NA intake manifolds and 240 turbo pans for sale. Need d24 or d24t parts? PM me! Shipments done on fridays! 1982 242 D24+T/M46- Super pumped! Build thread: http://www.d24t.com/showthread.php?t=1545 1984 764 D24T/ZF build thread: http://www.d24t.com/showthread.php?t=1734 Diesel parts cars: 82 244,83 244, 84 244, 84 245, 85 745 |
#22
|
|||
|
|||
Yes indeed. Those holes are to direct coolant at the exhaust ports.
__________________
Thanks, Jim C. 1985 745 TD MT (project) 1986 A2 Golf GTDI swap LeMons racer (very not stock) 2001 Golf TDI (not stock) |
#23
|
|||
|
|||
That's good to know thanks, the engine is fitted to a boat, I have just remembered that about 4 years ago the sea water pump which is located just over the front of the engine leaked saltwater over the engine, it is possible that the end of the camshaft has become rusty and damaged the seal. I may just put up with it until the end of the season as I don't have time at the moment to strip it down.
Thank you for your help. |
#24
|
|||
|
|||
Quote:
The Evans waterless coolant is high viscosity that concentrated antifreeze, almost a mineral oil. The printed instructions I got said remove the Tstat and all any bypass. The UK instructions on line say don't do any of that, leave the mechanics alone and clean and fill. The two extreme modes for the cooling system in my application are: 1. WOT up 10% grade to 14k feet, blowing 20psi of boost, pushing 8,000#. Here I need to suck all the heat out I can. 2. I stop at 14k ft and have lunch, the engine cools off. The engine idles 90% of the way back. Any heat produced is sucked out and I get white smoke and rough idle. I think I am really pushing the thermal loading envelope. So I added an extra cooling circuit for the inter-cooler, turbo and oil cooler. I can turn the pump and fan on/off separately. |
#25
|
|||
|
|||
Quote:
|
#26
|
|||
|
|||
Yes, I have two of the 4k GPs. I'll put one facing the engine when it get it running. Getting closer....
|
#27
|
|||
|
|||
Please post a link to your videos. Thanks a lot.
|
|
|