|
|
#15
05-14-2023, 08:10 PM
|
|||
|
|||
Hmm. I wonder if the greenbook gives it? Otherwise no idea here, at least. Maybe a good fastener supplier could figure it out with measurements. I certainly would think it is a pretty irregular size. A die to match it would probably only have one job to ever do -- cleaning up D24/T crankshaft bolts
 -- and I would not be surprised if it were expensive....What about a wire wheel on a bench grinder? I would not think the threads would suffer from that as long as you kept them parallel to the motion of the wheel and didn't go too nuts, no?
__________________
86 745 D24T/ZF 345k lifted 2.5" 83 764 D24T/M46 155k 
|
|
|
Threaded Mode