D24T.com  

Go Back   D24T.com > Technical Discussion Area > Diesel Engine and Drivetrain

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #11  
Old 06-20-2019, 06:16 PM
v8volvo v8volvo is offline
Supporting Member
 
Join Date: Jun 2009
Location: Montana, USA
Vehicle: '86 745, '83 764
Posts: 1,618
Default

I still suggest you keep your focus broader than just the injection pump for getting your setup dialed in. We'll help you assess the pump and rule out any issues with it and its installation, but I want to make clear that you're not going to see anyone here responding with a silver bullet solution you can bolt on to magically get a perfectly-running engine producing your desired power level simply by ordering the right part numbers, like you might have with a modern computerized engine or an old carbureted gas V8. We'd give you that answer if we could, but it doesn't exist. There are plenty of injection pump setups that, with the right comprehensive upgrades to other areas of the engine, can get you to 150hp or far beyond, but there's no "150hp pump" you can buy off the shelf. The engine can easily make that power but it cannot be extracted with a bolt-on approach.

Collective experience in the group here will help you get the truck running the way it should but we need to approach the engine as a whole system and rule out potential issues in a linear way. The pump is certainly ONE possible area for attention but the fact that you described issues that were intermittent, and most importantly the fact that you have observed NEGATIVE pressure in the intake manifold, still suggests that an air management issue may be at the core of the problems you're trying to solve or at least may be involved. It sounds like you made many, many changes to the engine all at once when you built it up with the (very nice) new turbo/fuel/inlet/exhaust system you have now. Doing everything together saves a lot of time but it means you can't see the independent effect of each change and any issues each change might introduce. Therefore if you need to troubleshoot after such a wide-ranging multi-system upgrade, you need to consider everything you touched, rule nothing out at the start and eliminate each possibility step by step.

Hope this is making sense. I'll make some suggestions and ask some questions about the injection pump and its installation on the engine, but in order for it to be worth folks' time to contribute help here, we'll need a lot of detailed info back from you in response to questions, maybe some pictures, and we'll all need to start on this same page before we begin: finding your issue could require investigating areas of the engine that you currently believe are not to blame.

If that plan seems logical and agreeable to you, let's start with these questions:

1) What method and specialized tools did you use to set the camshaft timing on the engine? Please provide a photo of the tool that you used to set the camshaft timing or cite the tool number.
2) What method and specialized tools did you use to install the injection pump the first time / that you plan to use when installing it now? Am I reading your earlier post correctly that you ONLY used the crude timing mark on the injection pump pulley to set injection pump timing?
3) What is the condition of the cooling system? If you get this engine producing the kind of power you're looking for, have you taken steps to enable the power to be used continuously without engine temperatures going out of control? Have you ever seen the engine temperature rise above normal operating temperature thus far? Do you have any other monitoring or alarm systems installed for keeping track of engine temperature and coolant reservoir level?
__________________
86 745 D24T/ZF 345k lifted 2.5"
83 764 D24T/M46 155k
Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -8. The time now is 12:30 AM.


Powered by vBulletin® Version 3.8.10
Copyright ©2000 - 2024, vBulletin Solutions, Inc.