#1
|
|||
|
|||
Installing monark nozzles.
Hello,
I am rebuilding my D24Tic completely, so I am also swapping nozzles as the old ones was very bad. I got myself a set of new Monark 39 305 138 that I found here on the Forum, and I am going to set the pop pressure to 2400psi, but I don't know where to get the shims needed.. Can someone help me out? Also, as the pop pressure are set higher, the timing of the pump should probably be a little different? What timing is preferred with the new nozzles? Best regards -E.Winjum |
|
|