#11
|
|||
|
|||
I did my swap into a 1992 700 series wagon. I too was faced with what to do with all the wires. Most of them I tie wrapped in place after insulating them. The ECU is still in place. I never really looked for it. I used the radio suppression relay for power to the IP solenoids and hooked up the oil and temp senders using the original harness.
All except 1 of the red battery cables I hooked back up again in order to make the ABS, air conditioning work etc. I did cut off the fuel injection cables but thats about all. Everything works except the tach and I have just bought a Dakota Diesel adaptor to make that work from the "W" terminal on the alternator. I also still have to fix up the electric cooling fan. I need a temp switch as my radiator does not have a place for one. I'm using the mechanical fan and shroud at present but I plan to replace them by taking the shaft out of the alternator bracket, leaving room for the electric fan between the engine and the radiator. Sorry I know little about 200 series cars but there is quite a lot in common between them so some of this might be helpful. Steve |
|
|