#1
|
|||
|
|||
tight leak off pipes
hi all i recently purchased a length of leak off pipe from Brickworks uk , the bore diameter is 3.2 mm which i believe to be correct for the D24 engine injectors
the the pipe is a very good quality but , a little tight on the edge that runs onto the injector i have tried and tried , question !. is it safe to try and force the leak off pipes over a couple of degrees with utmost care ? , to allow the pipe to sit snugly down at the bottom of the leak off pipe , i have replaced these pipe numerous time over the years with a budget range ,so i thought i woud get better quality i also purchased a genuine VW stop end whichich does fit snugly over the leak off pipe it is a thinner gauge too regards jim |
#2
|
|||
|
|||
Oftentimes you can make the rubber temporarily more compliant by heating it up immediately before fitting it. I use a heat gun.
__________________
1985 744 gle d24t 1985 745 gle d24t |
#3
|
|||
|
|||
940 tic auto 1995
THANKS FOR THAT ADVICE NGOMA .very good idea i will try this and let you know how i get on
regards jim |
|
|