|
|
#11
08-13-2015, 09:26 AM
|
|||
|
|||
Since Jason isn't on the board very often any more, it may be a little while before he sees this, but I remember him saying he did have a problem with leakage from that area and had to try to seal it up somehow. I think he said he eventually burned the trans up on a long trip after it ran low on oil.
__________________
86 745 D24T/ZF 345k lifted 2.5" 83 764 D24T/M46 155k 
|
|
#12
08-14-2015, 03:29 AM
|
|||
|
|||
|
Well thats not too encouraging!
It seemed like it had a small drain hole in that area to allow fluid back to the case.. But I tried to plug it off and isolate that entire area, and use grease as a lubricant instead. Evidently there is still fluid getting up there somehow. I may have to re-think the entire extended shifter mod. It would be nice to encase it all somehow... Spenser
|
 |
|
|
Linear Mode
