#1
|
|||
|
|||
240 D24 OE motor mounts NOS
Sold......
__________________
Mike Rausch Newark/Bear, DE Selling NEW and USED Volvo parts! www.swedishbrickyard.com Email: mike@swedishbrickyard.com Last edited by Volvoist; 11-11-2016 at 04:40 AM. |
#2
|
|||
|
|||
Sent you an email.
|
#3
|
|||
|
|||
Those mounts were listed "Sold" on Mike's EBay account shortly after he posted them here. He has been very insistent that D24 OE mounts will never be available again. Probably true. The passenger side engine mount for the 740 TD is still available from Volvo.
|
#4
|
|||
|
|||
I recently had both motor mounts and transmission mount replaced on my '85 740 and I don't think the garage had a problem getting the parts.
__________________
1985 740 GLE |
#5
|
|||
|
|||
I don't think they're hard to find aftermarket, but they're so cheap I'm skeptical of quality. About 10 each on iPd or FCP.
|
#6
|
|||
|
|||
cheap engine mount in d24t
I'm using one cheapo mount, made in india, $6 left side mount, with no problems since years ago. when I put it in, it looked softer and it may be. it tilted a bit too, but it hasn`t deformed any further.
if it goes bad earlier than the original Volvo mount, then you have more bricking.... Last edited by RedArrow; 09-11-2016 at 10:19 AM. |
#7
|
|||
|
|||
Quote:
__________________
Mike Rausch Newark/Bear, DE Selling NEW and USED Volvo parts! www.swedishbrickyard.com Email: mike@swedishbrickyard.com |
#8
|
|||
|
|||
I forget which side it was, but here in the US I kept getting some cheap skinny little thing for one side. I put it in anyway, and it squished way more than I liked. I ended up getting a transmission mount and using it instead, though it has no anti-rotation pins. But it was the original diameter of the engine mount and supported it much better.
This: http://www.rockauto.com/en/moreinfo....288537&jsn=383 vs this: http://www.rockauto.com/en/moreinfo....288537&jsn=382 If I remember right... -Spenser |
|
|