I followed that procedure over again, very very thoroughly at every step, with no success after a two hr 'job' (on jacks).
Is it possible that it now blew an internal older seal that hadnt been replaced? I used 6 parts only from the 12 piece kit. I highly doubt it blew an old seal but maybe.
What I dont doubt is me making a mistake at installation bc i was distracted by a vw golf full exhaust magnaflow installation project.
I wonder if my layout is correct bc that is how i put it all back in the pump. Anyone knows?
I suspect that #2 with the tiny filter (located in its left side in this picture) needs to be oriented the other way. Is that the case? It has a nut in its end and a mini filter.
I usually lay my stuff out at disassembly for picts but I may have confused myself with this one.
:-)
Last edited by RedArrow; 07-14-2020 at 06:37 PM.
|