Quote:
Originally Posted by Sethsquatch
OK so got some more info. He timed the motor to the spec in the pinzgauer service manual, which is (he didn't have it front of him) +085 or 088. Does that make sense?
|
Those bare numbers look familiar but this is a specific minute range, notice the decimal: Factory specs I'm looking at shows setting range from 0.75mm - 0.90mm, depending on version. Checking timing range = 0.72mm - 0.95mm. Not sure what the + sign means.
Quote:
Originally Posted by Sethsquatch
If the timing was 180 degrees off would the engine even run at all?
|
Yes, interestingly enough, here are two
recent accounts:
https://www.d24t.com/showthread.php?t=2071
https://www.d24t.com/showthread.php?t=2054&page=3
(starting at post #23)
NOT saying that is your problem, but the answer to your question is yes, engine can indeed run with IP 180 deg out.