You can measure it yourself, through the IP sprocket you will see the other hole that the pin will plug on the pump.
I can measure for you in a few mins too.
but, you can use a nice deep socket that is perfectly tight in there. give me a few mins...
Update.
The tool on top is the Volvo one
The one below is made by Matra
The length without the head is 35mm
The thickness is 15.4mm on the Matra VW tool and only 15.1 on the V tool but that has been actively used for decades by an old d24 builder. There's more than 0.3mm wear in his 90 year old elbows.
Last edited by RedArrow; 06-30-2020 at 10:54 PM.
Reason: Pics added
|