D24T.com  

Go Back   D24T.com > Search Forums
Register FAQ Community Calendar Today's Posts Search

Showing results 1 to 17 of 17
Search took 0.00 seconds.
Search: Posts Made By: mrvos
Forum: Diesel Engine and Drivetrain 11-08-2020, 04:45 PM
Replies: 32
Views: 21,667
Posted By mrvos
Yes, the timing is at 0.86mm i think, i will...

Yes, the timing is at 0.86mm i think, i will check it again but it doesn't seem changed. I checked it after a few miles after adjusting.

The injectors were done at a bosch shop, yes :) But they...
Forum: Diesel Engine and Drivetrain 11-08-2020, 09:53 AM
Replies: 32
Views: 21,667
Posted By mrvos
Hello everyone! Hope you are all well! ...

Hello everyone!

Hope you are all well!

Many things got in the way of all this - but its all done.

Checked valves - all good except for 6 which was o.k. but still i adjusted it
Installed...
Forum: Diesel Engine and Drivetrain 07-11-2020, 01:25 PM
Replies: 32
Views: 21,667
Posted By mrvos
I'm almost certain its not there. Also, this is...

I'm almost certain its not there. Also, this is an euro car.
Forum: Diesel Engine and Drivetrain 07-11-2020, 05:49 AM
Replies: 32
Views: 21,667
Posted By mrvos
These kits are nice, i didn't know anyone made...

These kits are nice, i didn't know anyone made them anymore. My harness isnt that type but it was touched by god knows who and always exposed to water and salt as there is no plastic skidplate...
Forum: Diesel Engine and Drivetrain 07-10-2020, 09:29 AM
Replies: 32
Views: 21,667
Posted By mrvos
Thanks :) I will reconfirm the timing, but...

Thanks :)

I will reconfirm the timing, but sounds okay.

The injectors were rebuilt.

I dont see the smoke sticky?

The engine starts great without plugs when its warm (the engine is warm...
Forum: Diesel Engine and Drivetrain 07-09-2020, 04:33 PM
Replies: 32
Views: 21,667
Posted By mrvos
Arrow It's done, the engine is set at 0.85mm exactly....

It's done, the engine is set at 0.85mm exactly. The car is much better now, ill explain soon.

Now i will explain what i did, the changes and the current situation of quite a bit of remaining...
Forum: Diesel Engine and Drivetrain 07-06-2020, 12:26 PM
Replies: 32
Views: 21,667
Posted By mrvos
Thanks! The bellhousing arrow is not as bad...

Thanks!

The bellhousing arrow is not as bad as i thought - photos are better than my eyes, and also the phone can get closer. I will try to view it perpendicular to the arrow, so that the arrow is...
Forum: Diesel Engine and Drivetrain 07-05-2020, 12:12 PM
Replies: 32
Views: 21,667
Posted By mrvos
Which greenbook do you have? Maybe i can find it...

Which greenbook do you have? Maybe i can find it too, mine looks to be original and is quite detailed. These values are repeated multiple times. But if your values are experimental, especially on a...
Forum: Diesel Engine and Drivetrain 07-04-2020, 05:15 PM
Replies: 32
Views: 21,667
Posted By mrvos
Thank you, this is great info! The greenbook...

Thank you, this is great info!

The greenbook manual recommends 0,65-0,73mm, that's all.

The method is interesting and i will give it a go, similar to greenbook but easier :)

The arrow is...
Forum: Diesel Engine and Drivetrain 07-04-2020, 04:17 PM
Replies: 78
Views: 42,761
Posted By mrvos
As far as i know from stories - the gasser...

As far as i know from stories - the gasser drivetrain (1983 B23 with carb, 4sp manual + od) and diesel engine are fully compatible, the only difference is in the transmission bellhousing (the starter...
Forum: Diesel Engine and Drivetrain 07-04-2020, 04:08 PM
Replies: 32
Views: 21,667
Posted By mrvos
The valve shims are the same as on Lada Samara...

The valve shims are the same as on Lada Samara (or some other lada not sure), 31mm, easy to get ~1euro a piece, so that is good info.

I am quite scared of dirt getting into the pump just from...
Forum: Diesel Engine and Drivetrain 07-04-2020, 10:06 AM
Replies: 32
Views: 21,667
Posted By mrvos
The pump is way off, probably 1.x mm instead of...

The pump is way off, probably 1.x mm instead of 0.x mm and the pump is already pushed inwards to the engine a lot if i recall correctly (not sure if it can even go anymore inwards) - god knows where...
Forum: Diesel Engine and Drivetrain 06-30-2020, 02:59 PM
Replies: 35
Views: 101,652
Posted By mrvos
Talking Do you know the diameter of the pulley lock pin?...

Do you know the diameter of the pulley lock pin? And maybe the length.

I will be making it so to eliminate a few iterations :D
Forum: Diesel Engine and Drivetrain 06-21-2020, 01:48 PM
Replies: 32
Views: 21,667
Posted By mrvos
Thank you! My vacation is in a week, so...

Thank you!

My vacation is in a week, so enough time then to check things out. By then i will source the parts.

I just read the greenbook and it looks like a relatively simple job, only rotating...
Forum: Diesel Engine and Drivetrain 06-21-2020, 05:08 AM
Replies: 32
Views: 21,667
Posted By mrvos
Do you have the d24 engine reconditioning...

Do you have the d24 engine reconditioning Greenbook book/owners manual? Highly suggested.

I have the greenbook service manuals in pdf and i can also share if anyone needs it.

About you...
Forum: Diesel Engine and Drivetrain 06-21-2020, 04:47 AM
Replies: 32
Views: 21,667
Posted By mrvos
Thank you! And thank you for the long and quick...

Thank you!
And thank you for the long and quick answers!

The car is actually a 245, and i have also other old cars (including a for spares same 245 diesel and a 244 b21).

I dont visit any...
Forum: Diesel Engine and Drivetrain 06-20-2020, 05:03 PM
Replies: 32
Views: 21,667
Posted By mrvos
Question D24 na problematic everything

Hello all!

May be you can help me. I have read almost a hundred threads, but this is my first writing :)




I have a Volvo 240 with D24 non turbo. Manual + OD. I will list problems here...
Showing results 1 to 17 of 17

 
Forum Jump

All times are GMT -8. The time now is 06:53 AM.


Powered by vBulletin® Version 3.8.10
Copyright ©2000 - 2024, vBulletin Solutions, Inc.