D24T.com  

Go Back   D24T.com > Search Forums
Register FAQ Community Calendar Today's Posts Search

Showing results 1 to 25 of 27
Search took 0.00 seconds.
Search: Posts Made By: blix99
Forum: Diesel Engine and Drivetrain 06-07-2021, 12:27 AM
Replies: 27
Views: 18,237
Posted By blix99
Thanks very much both of you. I appreciate...

Thanks very much both of you.

I appreciate it. I recently bought an old side-valve motorbike that I can't get running now. I must enjoy this stuff in some deep recess of my brain.

I'm a glutton...
Forum: Diesel Engine and Drivetrain 06-04-2021, 05:27 AM
Replies: 27
Views: 18,237
Posted By blix99
Update - finally!!

So, it's been a massive delay since i last posted but, this is because of lockdown and much work to do, I haven't had a chance to actually drive the van any great length.

However, I finally got to...
Forum: Diesel Engine and Drivetrain 09-01-2020, 10:08 AM
Replies: 27
Views: 18,237
Posted By blix99
Thank you so much for such a comprehensive reply....

Thank you so much for such a comprehensive reply. You come to more or less the same conclusions as me, all though I'm much less qualified : ) I generally make everything up as i go along!!.

So,...
Forum: Diesel Engine and Drivetrain 09-01-2020, 07:16 AM
Replies: 2
Views: 4,211
Posted By blix99
Superb. You should get this added as a sticky. ...

Superb. You should get this added as a sticky.
Thanks very much. I'm off to find some now : )
Forum: Diesel Engine and Drivetrain 09-01-2020, 03:34 AM
Replies: 27
Views: 18,237
Posted By blix99
Also, in the diagram above, No. 5 isn't there...

Also, in the diagram above, No. 5 isn't there either unless it's part of the hose? This section is all one molded , rubber part.

Also, when filled up and running, all hoses seem to be full. They...
Forum: Diesel Engine and Drivetrain 09-01-2020, 03:28 AM
Replies: 27
Views: 18,237
Posted By blix99
Thanks for ther link. Out of stock on Brickwerks...

Thanks for ther link. Out of stock on Brickwerks but I'll keep an eye on it.

OK. The saga continues to waste my time. I have so much other stuff to do on this van, the overheating is getting me...
Forum: Diesel Engine and Drivetrain 09-01-2020, 02:44 AM
Replies: 2
Views: 4,211
Posted By blix99
Best oil for 2.4D DW?

Hi there. I have a 1983 2.4D DW in a VW LT camper van, in the UK.
I've read a few posts; here and on other forums, about which oil to use but nothing seems conclusive.

Mineral? Semi Synthetic?...
Forum: Diesel Engine and Drivetrain 08-30-2020, 11:59 PM
Replies: 27
Views: 18,237
Posted By blix99
Hello. Thanks again for the reply and advice. ...

Hello. Thanks again for the reply and advice.

I actually followed my assumptions and have put it all back together and retimed the IP too. All seems to run like before and it didn't blow up on the...
Forum: Diesel Engine and Drivetrain 08-30-2020, 03:55 AM
Replies: 27
Views: 18,237
Posted By blix99
OK. I took the end sprocket off of the cam; the...

OK. I took the end sprocket off of the cam; the IP end. This end of the cam has an offset slot. This is where the VW locking tool goes. I made own just now and I assume when the crank is TDC, the...
Forum: Diesel Engine and Drivetrain 08-30-2020, 01:04 AM
Replies: 27
Views: 18,237
Posted By blix99
Hey guys. Sorry for radio silence on this for a...

Hey guys. Sorry for radio silence on this for a while. I really appreciate your input. I have been trying different things to solve this. Taking out the tstat isn't the problem. It's continually...
Forum: Diesel Engine and Drivetrain 08-22-2020, 05:39 AM
Replies: 27
Views: 18,237
Posted By blix99
Hello. Thanks for all your replies and help. ...

Hello.
Thanks for all your replies and help.

So, I removed the new tstat that I fitted and checked that, along with the old one. Both seem to work OK but the new one opens more.

Also, the new...
Forum: Diesel Engine and Drivetrain 08-20-2020, 10:21 AM
Replies: 27
Views: 18,237
Posted By blix99
Hey. Thanks very much for the reply and the link...

Hey. Thanks very much for the reply and the link / photo.

I had seen the Brickwerks unit and understand that the 80deg one is better than the 87 deg standard unit. However, all this was gleened...
Forum: Diesel Engine and Drivetrain 08-20-2020, 02:54 AM
Replies: 27
Views: 18,237
Posted By blix99
2.4DW in VW LT - Overheating on short runs - no load

Hello.
I've just got my newly aquired VW LT camper on the road after over 4 years sat idle.
I spent a lot of time trying to get the engine to run OK (IP pump seal and timing, new injectors, new...
Forum: Help! My car died! 04-27-2020, 12:45 AM
Replies: 14
Views: 31,079
Posted By blix99
Hello. I know I keep saying, 'Thanks for the...

Hello.

I know I keep saying, 'Thanks for the reply' but I really do appreciate it as I'm learning all the time with this engine.
I'm either used to basic, old, VW air-cooled engines and some...
Forum: Help! My car died! 04-25-2020, 02:29 AM
Replies: 14
Views: 31,079
Posted By blix99
Hi again. Thanks again for the reply. ...

Hi again.

Thanks again for the reply.

I'm not sure of the nozzles in the new injectors as they are fitted now and would also require taking them apart to see.

It might have been on the box...
Forum: Help! My car died! 04-23-2020, 04:05 AM
Replies: 14
Views: 31,079
Posted By blix99
Hi. Thanks again for the reply. So, I did...

Hi. Thanks again for the reply.

So, I did decide to buy new injectors but they are set up for DV engine (D2.4t so I understand)

I have fitted them as I needed to get the engine going again (and...
Forum: Help! My car died! 04-16-2020, 02:03 AM
Replies: 14
Views: 31,079
Posted By blix99
Thanks very much again for such a comprehensive...

Thanks very much again for such a comprehensive reply.
I'm always tempted to get the tools to do this myself. I'm always in the market to learn new things but, I have to stay focused : )

I just...
Forum: Help! My car died! 04-15-2020, 02:31 AM
Replies: 14
Views: 31,079
Posted By blix99
Ha ha. My naivety strikes again :rolleyes: ...

Ha ha. My naivety strikes again :rolleyes:
Thanks very much for your frank reply.

Your description exactly describes what I expected initially; actually I never even gave it a thought. You live...
Forum: Help! My car died! 04-14-2020, 01:44 AM
Replies: 11
Views: 30,065
Posted By blix99
She's good at steering; just can't reach the...

She's good at steering; just can't reach the pedals : )
Forum: Help! My car died! 04-14-2020, 01:41 AM
Replies: 14
Views: 31,079
Posted By blix99
Hi guys. Thanks for the replies. I've...

Hi guys. Thanks for the replies.

I've changed the internals of each injector for new - this is just the lower part; needle and nozzle. They are all Bosch - made in France and came wax coated. I'm...
Forum: Help! My car died! 04-13-2020, 08:32 AM
Replies: 14
Views: 31,079
Posted By blix99
Help II - 2.4d DW engine - Noise when revving

Hello.

This engine is really testing my resolve.
It's in a 1983 VW LT camper. I've had it about 2 months.
Trailered it onto my drive after buying it and there it's sat ever since : (

Anyway....
Forum: Help! My car died! 04-13-2020, 07:58 AM
Replies: 11
Views: 30,065
Posted By blix99
Unhappy Hello again. Sorry for the delay in...

Hello again.

Sorry for the delay in replying. I'm still trying to get my van engine to work properly. I have a new question but will post that separately.

Here are a couple of photos of what my...
Forum: Help! My car died! 03-23-2020, 02:33 AM
Replies: 11
Views: 30,065
Posted By blix99
Whoo bloody hoo : ) ...

Whoo bloody hoo : )

https://drive.google.com/open?id=1NrPJKXegY1CJaXytjkyVnGEH0rpgWPXX

Bought a timing gauge, just a cheap one. The brass rod that came with it; to place inside the end of the...
Forum: Help! My car died! 03-18-2020, 12:19 AM
Replies: 11
Views: 30,065
Posted By blix99
Thanks so much for taking the time and such a...

Thanks so much for taking the time and such a comprehensive reply.

I didn't move anything when taking the IP pulley off, so am pretty confident that it's TDC on No1, as this is where it all was...
Forum: Help! My car died! 03-16-2020, 11:59 PM
Replies: 11
Views: 30,065
Posted By blix99
Thank you both for your replies and advice. ...

Thank you both for your replies and advice.

OK. I'll get a gauge and set the timing properly.

I did intend to borrow / buy a gauge, because I'd like to get it spot on, but thought that setting...
Showing results 1 to 25 of 27

 
Forum Jump

All times are GMT -8. The time now is 07:01 AM.


Powered by vBulletin® Version 3.8.10
Copyright ©2000 - 2024, vBulletin Solutions, Inc.