|
#1
|
|||
|
|||
Resurrection of the 81
This Thread is dedicated to the revival (hopefully) of the non-runner, rusty&corroded D24 I recently found.
It will take a long time, there`s a lot to check& do... It`s definitely not a pretty beauty but that is exactly what makes it much more interesting: being more of a challenge... I`m planning to share the projects (issues) and organizing my questions (and pictures) here. (The three-speed tranny and the shell went to the junkyard.) Last edited by RedArrow; 07-27-2015 at 03:02 PM. |
#2
|
|||
|
|||
some of my first shots of the green block
Very rough condition... I`m thinking now, most likely it won`t be a runner ever again. So far, a visual Inspection only; but already seeing Multiple problems to solve (if possible at all).
...to be continued tomorrow.. Last edited by RedArrow; 07-27-2015 at 03:02 PM. Reason: picture was added to the post |
#3
|
|||
|
|||
What was it out of? I notice the right side of the oil pan is very shallow compared to a D24 from a volvo. If you cannot salvage the engine as a whole, you may have a lot of decent parts still. I figure internal inspections would be the most tell tale... once you pull the head and the pan, you should know right away if it is savable. The outside only says so much.
Spenser |
#4
|
|||
|
|||
Investigating the d24:)
Quote:
About the oil pan, idk, will have to compare them but I think it is the factory setup (i have pictures taken from bizarre angles). And finally; yes, many good parts are still present! It wasn`t me who trashed the rest of the vehicle (i would have kept more of the crutial things {if they were still usable..?...} ) Quote:
The engine turns over btw. I can`t wait for the freaking weekend for further inspection, maybe a possible tear down of the accessories and possibly the head with the pan. Till then it`s soaking in wd40 all over. Multiple spots indicate that terrible awfulness, long-term neglection then unskilled tinkering have been going on. I have now the strange feeling that after seeing the head I will close the book. What do you guys use as the best engine stand for these engines? the ones i have are pieces of crap. Thanks for reading. Wish me `luck`. Last edited by RedArrow; 07-04-2020 at 03:00 PM. Reason: Picture added |
#5
|
|||
|
|||
Quote:
Never had any issues with it. I had to pick up longer bolts and two nuts, but no big deal. I mounted mine by the starter bolt holes and two other bell housing bolts on the opposite side. |
#6
|
|||
|
|||
I looked at the same stand. Cool,thx. I attached picts of the pan...
|
|
|