D24T.com  

Go Back   D24T.com > Technical Discussion Area > Help! My car died!

Reply
 
Thread Tools Display Modes
  #11  
Old 11-10-2017, 07:30 PM
ngoma ngoma is offline
Senior Member
 
Join Date: Nov 2009
Posts: 579
Default

Yes that does make sense. I am remembering something about the early 1.5 blocks with 11mm headbolts suffering from cracks around the bolt holes.

More progress:

Chased/cleaned the bolt holes

Cleaned up the block deck. I really like that super scraper.

Cleaned up the piston tops and measured piston protrusion with a small stout straightedge and feeler gauges:

#1 .026
#2 .016
#3 .034
#4 .032
#5 .034
#6 .032

What's up with outlier #2? No signs of valve collision on piston top.

Looks like I go with 2-notch head gasket, here are the specs:
mm (in)
0.81-0.90 (0.032-0.035) 2-notch
0.91-1.02 (0.036-0.040) 3-notch

It had a 3-notch replacement gasket. I think repair shops commonly replaced head gaskets w/ 3-notch across the board. Easier to stock one gasket version, and no having to measure/ no chance for valve interference. The tradeoff is lower performance.

Here are photos of the piston tops. Can anyone decipher the markings?
P1020688.JPG

P1020689.JPG
__________________
1985 744 gle d24t
1985 745 gle d24t
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -8. The time now is 08:56 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2018, vBulletin Solutions, Inc.