|
#1
|
|||
|
|||
Where to Boost Controller?
I have a cheap ebay boost controller that I used on my 740turbo gasser that worked great, which hose do I split and install it on my stock d24t turbo? The larger hose?
|
#2
|
|||
|
|||
If its original d24t, cut the hose going to LDA-controller on fuelpump,
and take pressure-info there, it comes to that hose from intake manifold. |
#3
|
|||
|
|||
do you mean that's where I hook up boost gauge?
|
#4
|
|||
|
|||
There is two hoses that go to boost actuator which one can I regulate, the larger one is what I am thinking because the smaller one goes from the compressor inlet before turbine to actuator. I want to get it on there before i put manifold back on. Any help is much appreiated
|
#5
|
||||
|
||||
Yes install it to in the hose that comes from the compressor housing. The hose that goes to the bottom of the inlet is a oil drain or something stupid. I would install a boost gauge too. I wouldn't push too much more than 15lbs without doing some work.
Jason
__________________
Back again with a '84 760 GLE D24T/ZF SOLD but not forgotten! 1984 760 Sedan, built D24Tic/ T-5 swapped My engine build: http://www.d24t.com/showthread.php?t...t=engine+build T-5 swap: http://d24t.com/showthread.php?399-W...to-quot-w-pics! |
#6
|
|||
|
|||
Have steel head gasket and boost gauge, I haven't figured out a good way to pipe the intercooler I got from 740turbo,(smaller rad?), How much boost should I run?
|
|
|