#11
|
||||
|
||||
They had a sleeve kit for a d24? Thats suprising. I'm guessing where the seal rides has a ridge or some pits from rust? Normally a little wear grove isn't going to make it leak if the seal is fresh, but pits will. How is the area of the crank just behind the seal? I have trimmed the backside of the outer flange of a seal before to get the seal to set in a little farther so it rides on a fresh area. I suppose if you have the kit though not much need to do that. I don't see why you would have to remove the oil pump though.
Jason
__________________
Back again with a '84 760 GLE D24T/ZF SOLD but not forgotten! 1984 760 Sedan, built D24Tic/ T-5 swapped My engine build: http://www.d24t.com/showthread.php?t...t=engine+build T-5 swap: http://d24t.com/showthread.php?399-W...to-quot-w-pics! |
|
|