Oil on top of valve cover

[Hendo]

Car is '82 245 with stock non-turbo D24 engine. 108,000 miles.

I'm seeing oil collecting on top of the valve cover, near where the vent hose attaches. (The other end of that hose connects to the

I wipe it off with a rag, and it reappears after a hundred miles or so. There isn't a lot, but enough to be noticeable.

I can easily wipe it up but I was wondering if that was telling me something... Or if it indicated an issue of some sort...

Engine doesn't use a lot of oil; it is down a little more than half a quart since the oil was changed 1300 miles ago.

Thanks in advance...

Tom in SoCal

[745 TurboGreasel]

I see often someone has replaced the breather hose with coolant hose...which does not hold up well to oil.
Or the original hose is dry and cracked.

[Hendo]

This was my dads car, and was mostly dealer-maintained but it had little attention for ten years or so... So I suspect it is the right part but old.

Time to look for a replacement...

Thanks for your thoughts.

-tom in socal

[v8volvo]

Originally Posted by 745 TurboGreasel

Or the original hose is dry and cracked.

Likely the issue if the hose has never been changed... you could try cranking down the clamp a bit more but the hose is already hard and squashed down like most of them are, unlikely it'll make a lot of difference.

Think I remember that those hoses are NLA from Volvo now, but there are other solutions if it needs replaced.

[Hendo]

The good news is I was able to source a replacement breather hose via the dealer. It was backordered to Sweden so it took a while but it has arrived.

Hopefully the old one will come off without too much trouble. The valve-cover end appears to be all-metal so I'm not to worried about it. The other end (on the engine air intake hose) looks fragile... hopefully it won't take too much horsing around to remove the old hose.

Hendo

[RedArrow]

Share the source pls.thanks!

[Hendo]

I just saw this reply -- sorry for the late response! I'm not sure how I missed it, and since this was from a while ago, it may be old news, but here goes.

I ordered the part from Smith Volvo, in San Luis Obispo CA. Tim has been the parts manager there for many years and has always been helpful.

https://parts.smithvolvo.com/p/Volvo...9/1257565.html

Not much to it for $28 but such is life. It fit well and greatly reduced the oil grunge that was collecting on the top of the valve cover.

I hope this will be helpful for somebody.