|
#1
|
|||
|
|||
--Moved-- New from PDX
Figured I'd say hello.
Getting ready to acquire tools to to the T-belt and re-time the injection pump and do glow plugs. Recommendations for where to buy the special tools, a replacement cold start device, replacement engine wiring harness, fresh water pump,, fresh nozzles with a rebuild procedure and fresh glow plugs and all that? It's about to need a t-belt. Advancer lever works on the injection pump (verified), compression is good, timing seems a bit off, it is extremely loud when moving the advancer lever (for cold start device) into the advanced position (cold start device disabled, idling speed raised to compensate). Is it possible to update to the 84.5+ glow plug relay arrangement? I pulled one of those relays, but mine, being an '83 265GL M46, has the 2 relay setup and is awkwardly stuck on. I'd be fine with fixing the 2-relay arrangement I guess, as long as I can wire in a larger relay to carry the current. More interested in quality lasting repairs than temporary. Need the cold start device, doesn't want to fire up when it is 27F out, but if you zip-tie the lever all the way advanced it starts, though it runs waay scary noisy like that, so I'm guessing someone kinda split the difference on the advance on that. Have met Kevin, SMN3D, casioqv in person. Never met V8volvo. I used to passionately hate these, as you'd never make book time flat rate on them, stink of diesel, and 1/8" cracks in the head were allowable per the book :wtf: Now, I'm kinda OK with it given it's my car and I don't have to hustle too much...and old car is an old car. James from PDX. Last edited by Fridgewagon; 11-20-2014 at 11:54 PM. |
#2
|
|||
|
|||
Quote:
What is the state of the altitude compensator? Should be receiving +12VDC, otherwise it can be adding additional advance. Most cold start problems involve the glow plugs. Depending on the engine and environment, one bad GP cause hard starting, two bad GPs can make starting near impossible. If your GP relay is always stuck on, you may have damaged one or more GPs. I don't see why you can't upgrade the relay to the newer. If you do, get the newest version as it is reprogrammed to glow better for those problematical warm starts, and provide afterglow. For parts, I have used autohauszaz.com, gowesty.com, fcpeuro.com, ipdusa.com, tasca, rockauto. We like the Monark injector nozzles, info somewhere in this forum. When changing the t-belt, it makes sense to replace the idler, and the IP belt at the same time. I think Volvo coldstart waxstat is currently cheaper than from Bosch. Try tasca for that. Where are you located? Maybe another nearby member has timing tools they can loan you?
__________________
1985 744 gle d24t 1985 745 gle d24t |
#3
|
|||
|
|||
Located in Portland, OR.
Moving the lever all the way to advanced makes it possible to start in the cold, though very loud and scary sounding, have no verified timing. I know the #6 glow plug is dead and have stopped driving it due to mostly that. I have no trouble hot starting it whatever (no glow). It can be a pretty cold day and it will snap right to life even if left to sit for an hour+ or more at 30F or something. Warm days, you barely had to glow it and it would snap to life almost immediately. I just want the glow plug circuit to work reliably and not stick on and fry the glow plugs or risk frying them mostly. Glow plugs that last the longest? Help? |
#4
|
|||
|
|||
Teh Bosch Duratherms are self regulating and seem to hold up well...
Though I did run Chinese no name glows for 2 years and thy were still fine when i replaced em. |
#5
|
|||
|
|||
2nd the Bosch Duratherms. Should last several years if the timing is not overly advanced, and avoid the ether. Stay away from the Autolites, known to mushroom and disintegrate inside the head.
Quote:
Make sure the GP relay is seeing the head temp. signal. Usually a brown wire coming off of the temp sensor at the rear of the head, just below the rear cam sprocket. If disconnected, the open connection fools the GP relay into thinking it's max cold and requires max GP time.
__________________
1985 744 gle d24t 1985 745 gle d24t |
#6
|
|||
|
|||
I suspect the timing is over-advanced. Idles a little fast hot, sounds TERRIBLE with the advance lever pulled via the cold start device actually connected.
Will replace the 2 dead glow plugs that are obviously open circuit. I'm sure that doesn't help start-up. Plenty of deferred maintenance needed: Tbelt(s0, water pump, tensioner, head rebuild, glow plugs, glow plug circuit, cold start device (less critical), probably rebuild the injectors. Has a fresh injection pump and is pretty "fast" for a diesel. If its ~60F out or warmer, needs only brief glow once in the morning while its cold, then good the rest of the day thereafter basically. No afterglowing or anything really needed. |
#7
|
|||
|
|||
Is your cold start failed on and alt compensator not on with the key?
|
|
|