|
|
#1
05-28-2015, 02:29 PM
|
|||
|
|||
Will one piece thrust bearings work in place of the 3 piece?
I am in the middle of a rebuild on a D24T.... I had ordered the set of crankshaft bearings that included the one piece thrust bearing. Once I tore the engine down, I found that it had the 3 piece thrust bearing. I ordered this from Rockauto, but the set came incomplete, missing the thrust bearing parts. It was the last one - now they do not have the parts I need and can only give me a refund. So my question is: is it OK to use one in place of another? They seem to fit correctly.. But I don't want to mess anything up. I attached a picture that shows one of each type.
Spenser 
|
|
#2
05-28-2015, 08:17 PM
|
|||
|
|||
|
Yes they will interchange, check end play.
__________________
12mm pump heads, ARP stud kits and GTD nozzles available! http://d24t.com/showthread.php?t=1646 NA intake manifolds and 240 turbo pans for sale. Need d24 or d24t parts? PM me! Shipments done on fridays! 1982 242 D24+T/M46- Super pumped! Build thread: http://www.d24t.com/showthread.php?t=1545 1984 764 D24T/ZF build thread: http://www.d24t.com/showthread.php?t=1734 Diesel parts cars: 82 244,83 244, 84 244, 84 245, 85 745
|
|
#3
05-29-2015, 02:42 AM
|
|||
|
|||
|
OK thanks!
I finally Primed the block last night.... It's going green when I get home from work today! Here's a before and after picture:
|
 |
|
|
Linear Mode
