#1
|
|||
|
|||
opinions on adding a turbo to a NA D24
So I have spoke with a few folks on this matter. I have a 1984 244 Diesel and it has just over 90K original miles on it . The car has cost me almost nothing as I have been able to piece together parts from my collection of junk to keep the car going good. The D24 is mated to the BW55 .. the auto 3 speed. I can only do about 21mpg in this car . I have the engine tuned well from what I read. I have it set right at the line of blowing smoke. So it doesn't blow fuel out the tailpipe . I do get a lot of blow by though.
I really think this engine should do better on the mpg . I am going to getting the manual bell housing and I have the rest of the parts to convert it like the flywheel and such . But until then I was wondering what everyones thoughts were on putting stock turbo parts from a D24T on the engine. So from what I have gathered the D24 came with a lower zinc cast block and the D24T was a higher Zinc based block . From what I have been told adding a turbo would most likely wear the engine out sooner on the D24 and it can't handle it. is this true? I just want to add a little bit of pep to the car with a small turbo and increase its efficiency .
__________________
1984 244 Diesel, 1989 244 Diesel, 1979 242 GT , 1978 264GL, 1958 PV444, 1988 244 DL , 1986 245 GL , 1970 164 , 1967 122S 2dr, 1966 122s 4dr, 1982 Volvo F613, 2008 Ford F250 4x4. |
#2
|
|||
|
|||
21 mpg is horrible, I've never driven an auto d24 but I assume it should do better then that!
I have added turbos to many d24 engines, I have never had any issues. Keep the EGT's down and the engine longevity will not be affected. The D24 being said as having softer blocks is just a myth. I have built around 10 of these engines. It's seems the d24 and d24t wear equally the same. If you need help tracking down any parts, send me a pm.
__________________
12mm pump heads, ARP stud kits and GTD nozzles available! http://d24t.com/showthread.php?t=1646 NA intake manifolds and 240 turbo pans for sale. Need d24 or d24t parts? PM me! Shipments done on fridays! 1982 242 D24+T/M46- Super pumped! Build thread: http://www.d24t.com/showthread.php?t=1545 1984 764 D24T/ZF build thread: http://www.d24t.com/showthread.php?t=1734 Diesel parts cars: 82 244,83 244, 84 244, 84 245, 85 745 |
#3
|
|||
|
|||
Thanks ! I will be sending you a PM shortly .
__________________
1984 244 Diesel, 1989 244 Diesel, 1979 242 GT , 1978 264GL, 1958 PV444, 1988 244 DL , 1986 245 GL , 1970 164 , 1967 122S 2dr, 1966 122s 4dr, 1982 Volvo F613, 2008 Ford F250 4x4. |
#4
|
|||
|
|||
I understood that the NA blocks, lacked the under-piston oil squirters of the D24T/TiC.
Equally, I also heard that they were not needed.
__________________
1989 VW LT28 2.4D I like them simple, like me. Now playing....BBCRadio 6Music..... |
|
|