D24T.com  

Go Back   D24T.com > Technical Discussion Area > Performance and aftermarket

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #1  
Old 06-01-2017, 12:06 PM
718Pinz 718Pinz is offline
Junior Member
 
Join Date: Jan 2015
Posts: 27
Default Boost, EGT and smoke issues....

Hello everyone. I need some of your collective knowledge to help with my problems. Here is where I am sitting engine-wise:

Rebuilt motor bored to largest oversized pistons
12mm pump
Turbonetics Super 60 T3 with .82 ar
Turbonetics WG
Turbonetics manual boost controller
Air/water intercooler
Boost gauge
EGT
ARP Head Studs
3" DP

Now to the problems:

-Not building more than 10 lbs of boost...why?

-Black clouds of smoke (I think I about have this figured out)

-IP timing set to .96. Make minor adjustments with the inboard/outboard rotation. Outboard (to driver side) brings the EGT's down and runs better. Inboard raises EGT's and runs worse.

-Boost builds, then falls off at the high side of the rpm's. I initially thought it was due to excessive back pressure so I went up to a 3" down pipe. It helped with the smoke issue and seemed to help overall, but something is causing the boost to fall off and not reach over 10 lbs. My target boost is 20 lbs...just can't get there for some reason.

Any suggestions?

Thanks,
Phil

Last edited by 718Pinz; 06-01-2017 at 12:48 PM. Reason: Update about Boost falling off
Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -8. The time now is 10:30 AM.


Powered by vBulletin® Version 3.8.10
Copyright ©2000 - 2024, vBulletin Solutions, Inc.