#11
|
|||
|
|||
500psi is normal IMO, I did dry and hot, I did the retorque, I already have 2,500 miles on the head. I do about 400+ miles on one quart of oil. Its not bad but very annoying, and the oil isn't cheap either.
Here is a picture of my oil return line, I think this the problem to the whole thing. I'm using a d24 oil pan on the D24T block, but How the motor sits at a 10 degrees and I'm thinking the oil is backing up through the turbo. Its such a low spot on the pan verse the drivers side sit much higher. I have only done this swap twice, my car and my friends 240 wagon. He is using the same set-up that I'm doing but his drain is in a higher location on the pan. VIDEO
__________________
84-264 D24 M46 135K 33MPG 84-D24T 84-764 D24T M46 86-245 B230 366K 83-244 Turbo B21FT M46 72-145 B20 M40 77-245 B21ft project 78-242 B21f BW55 97K 79-242GT B21F M46 165K Biodiesel Processor For Sale |
#12
|
|||
|
|||
I'm going to try to relocate the drain with out taking out the whole motor. I might have to cause I don't want metal shavings in the pan.
__________________
84-264 D24 M46 135K 33MPG 84-D24T 84-764 D24T M46 86-245 B230 366K 83-244 Turbo B21FT M46 72-145 B20 M40 77-245 B21ft project 78-242 B21f BW55 97K 79-242GT B21F M46 165K Biodiesel Processor For Sale |
#13
|
|||
|
|||
Nice fittings and weld job there! I would agree, seems logical that that position for oil return might be susceptible to backups and stoppages, especially while cornering.
__________________
1985 744 gle d24t 1985 745 gle d24t |
#14
|
|||
|
|||
Quote:
I shim the right side of the motor. The motor sits a lot more level, but still burning oil. What would make the oil rings fail?,
__________________
84-264 D24 M46 135K 33MPG 84-D24T 84-764 D24T M46 86-245 B230 366K 83-244 Turbo B21FT M46 72-145 B20 M40 77-245 B21ft project 78-242 B21f BW55 97K 79-242GT B21F M46 165K Biodiesel Processor For Sale |
#15
|
|||
|
|||
OH man... I had the same problem! I hope your engine was not improperly built like mine was. You can always run the car with out the turbo to see if will still smoke.
__________________
12mm pump heads, ARP stud kits and GTD nozzles available! http://d24t.com/showthread.php?t=1646 NA intake manifolds and 240 turbo pans for sale. Need d24 or d24t parts? PM me! Shipments done on fridays! 1982 242 D24+T/M46- Super pumped! Build thread: http://www.d24t.com/showthread.php?t=1545 1984 764 D24T/ZF build thread: http://www.d24t.com/showthread.php?t=1734 Diesel parts cars: 82 244,83 244, 84 244, 84 245, 85 745 |
|
|