#11
|
|||
|
|||
Uh oh, hope it hasn't been full for too long and blocked people out. I didn't realize I was not able to receive PM. Sorry about that.
Email is a better way to get hold of me, I don't always do a good job checking my PM. You can reach me at g30rg3 dot a11is0n at gmail dot com (change the numbers to corresponding lowercase letters for the address, e.g. 3=e, 0=o, 1=l). I'm out of town until Wednesday but have internet access.
__________________
86 745 D24T/ZF 345k lifted 2.5" 83 764 D24T/M46 155k |
#12
|
|||
|
|||
If you want to make your own or have one made, I have a drawing of a crank holding tool I had made and I would email it to you if you want it.
Steve |
#13
|
|||
|
|||
Could be use full posting the picture up or a link to it because I no I would be interested aswel.
|
#14
|
|||
|
|||
Ok well I just have to figure out how to get it on here. Not very savvy I'm afraid but give me a little time
Steve |
#15
|
|||
|
|||
|
#16
|
|||
|
|||
Yeah the attachment works
Thanks |
#17
|
|||
|
|||
Availability of crank holder tool. Or drawing of tool.
Being new to the 2.4TD and my similar 2.0TD I need to acquire a few tools, one being the crank holder. To revive this thread...are these available anywhere? Does anyone have the drawing that piper109 referred to? I'm asking these questions prior to receiving my "green book" which is enroute from eBay.
__________________
J.D. in Reno 1958 Mercedes 180D (rebuilding now) 1985 VW Jetta 1.6TD 1985 Volvo 745 Wagon 2.4TD (sold but still maintain it) 1987 VW Quantum Syncro 2.2 (converting to 2.0TD) 1996 TDI Passat 1997 Chevy 3/4 ton 6.5TD 2006 V10 TDI Touareg |
#18
|
|||
|
|||
Me too!
If we do get that dwg back up, I'll be having a go at making a hold tool as well... In the meantime, I'm gonna see if my local VW folks have one lying in a dusty corner somewhere!
|
#19
|
|||
|
|||
I'll just copy my old post from TB
Here are some of mine Pics for now, more detail later. In order of appearance: crank lock, IP cam pulley holder- universal pully holder- TDI cam pulley puller, works with generic 2 jaw, I think it will work on VW----27 MM performance tool deep socket, works on crank nut, and injectors, but you have to grind a taper on the tip.- front cam pulley holder gen one. crank tool assembled, works with 36" pipe wrench unassembled with a tape.... |
#20
|
|||
|
|||
Thanks for the pictures, is this tool shown being used in the Greenbook so I could use the motor to grab some dimensions and how to actually use it?
|
|
|