#1
|
|||
|
|||
i need a new cam !!!
i just got a engine its a 1995 d24tic ,960 i think ! on the way to my it got damaged and broke the pully on end of the cam . when i took the cover off i have found the cam is damaged to !!! where can i find the right cam for the engine ?
|
#2
|
|||
|
|||
|
#3
|
|||
|
|||
only one i can find is 05519 FEBI cam , ?
|
#4
|
|||
|
|||
That is too bad, looks like a hard hit, though it does seem those sprockets are actually quite fragile (I have fumbled a few) so maybe it was not as severe as it looks.
If you can find a new cam from Febi that should work well, their cams (and all of their parts) tend to be good quality. What damage was visible on the old cam? If it got a major impact on the end you may want to inspect the rear camshaft bearing cap and saddle on the head itself also, since those provide the thrust surfaces for the camshaft and would normally never see this type of force.
__________________
86 745 D24T/ZF 345k lifted 2.5" 83 764 D24T/M46 155k |
#5
|
|||
|
|||
thank you , i will take some pic when i pull the cam out .
|
#6
|
|||
|
|||
Let me know if you need a cam, I have a spare cam/head/pulley sprocket... if needed.
Last edited by monkeh; 07-20-2018 at 10:41 PM. |
|
|