Go Back   D24T.com > Technical Discussion Area > Performance and aftermarket

Thread Tools Display Modes
Old 11-11-2010, 09:47 AM
nick nick is offline
Join Date: Sep 2010
Location: St. Augustine, FL
Posts: 56

I think that spraying this fine mist of water/methanol will destroy your compressor wheel. It seems that water droplets contacting blades spinning at near 100,000 RPM would etch them over time. Have you had any problems with the compressor wheel or is this the motor that you are rebuilding?
Reply With Quote
Old 11-11-2010, 09:57 AM
Jason's Avatar
Jason Jason is offline
Join Date: Jun 2009
Location: St.Louis, MO
Posts: 1,246

No problem with the compressor wheel. Injecting water/meth pre turbo is common practice, especially on draw-thru carburated turbo setups. Obviously the best results would be direct port, and I'm sure over time the water will errode the compressor wheel, but in a draw through setup for example, so will the fuel hitting it. I have never seen that wear out or ruin a compressor wheel on a turbo. Dirt is a much bigger problem. That being said, I'm sure someone somewhere has ruined a turbo from injecting too much or doing it for a long period of time, but it would have to be a hell of alot of miles of use, and we are only talking about injecting this for a few seconds at a time at the most.


SOLD but not forgotten! 1984 760 Sedan, built D24Tic/ T-5 swapped
9.90@71mph in the 1/8th, 2.2 sec 60' (burning tires off through 1st gear)
My engine build: http://www.d24t.com/showthread.php?t...t=engine+build
T-5 swap: http://d24t.com/showthread.php?399-W...to-quot-w-pics!
Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -8. The time now is 06:33 AM.

Powered by vBulletin® Version 3.8.10
Copyright ©2000 - 2018, vBulletin Solutions, Inc.