D24T.com  

Go Back   D24T.com > Technical Discussion Area > Help! My car died!

Reply
 
Thread Tools Display Modes
  #1  
Old 07-13-2015, 03:30 PM
dannysauter dannysauter is offline
Junior Member
 
Join Date: Jun 2015
Posts: 1
Default Volvo runs for a few minutes and then dies

So I recently bought a 85 740 diesel that has been sitting for about a year because it died on the previous owner. At first i could not get it to start at all so I installed an electric in line fuel pump on it. Now it will fire right up but will only idle. If i press on the accelerator it will not rev up any higher. The car will run for about 5 minutes and then will die. I can start it again and it will continue to idle. I am assuming that the injection pump will need to be rebuilt but was wondering if there is anything else I should check.
Reply With Quote
  #2  
Old 07-14-2015, 07:25 AM
v8volvo v8volvo is offline
Supporting Member
 
Join Date: Jun 2009
Location: Montana, USA
Vehicle: '86 745, '83 764
Posts: 1,618
Default

Welcome to the board!

Very unlikely the problem is the injection pump. Try all other possibilities first.

Sounds like severe fuel system restriction. Did you change the fuel filter? Are there air bubbles in the transparent fuel line from the filter to the IP? Where did you install the electric pump?

How old is the fuel in the tank?

Where are you located?
__________________
86 745 D24T/ZF 345k lifted 2.5"
83 764 D24T/M46 155k
Reply With Quote
  #3  
Old 07-14-2015, 04:54 PM
FJ40Jim FJ40Jim is offline
Junior Member
 
Join Date: Sep 2010
Location: Ohio, USA
Vehicle: 745 TD
Posts: 14
Default

Dumb question, but are you sure the actual throttle lever on the IP is moving when the pedal is pressed? There is a complex path from pedal to cable to multistage bellcrank to IP.

If throttle lever is moving, the next thing to suspect is the governor linkage inside the IP is stuck. It can be disasssembled on-car for inspection.
__________________
Thanks,
Jim C.
1985 745 TD MT (project)
1986 A2 Golf GTDI swap LeMons racer (very not stock)
2001 Golf TDI (not stock)
Reply With Quote
  #4  
Old 07-15-2015, 07:19 AM
v8volvo v8volvo is offline
Supporting Member
 
Join Date: Jun 2009
Location: Montana, USA
Vehicle: '86 745, '83 764
Posts: 1,618
Default

Quote:
Originally Posted by FJ40Jim View Post
If throttle lever is moving, the next thing to suspect is the governor linkage inside the IP is stuck. It can be disasssembled on-car for inspection.
I respectfully disagree. A governor problem won't cause the engine to quit. I suspect the same thing that's making it quit is causing it to be unable to raise engine speed. A fuel supply restriction will do that.

If there is indeed a problem in the IP, I'd suspect stuck transfer pump vanes. That would explain failure to start until positive pressure were applied via a booster pump, and inability to run properly now.

But first step without question is to look for a blockage in the fuel system. That's both the most likely, IMO, and by far easiest/cheapest to find and fix. Things like that are always the best starting point!

OP, how does it run when it's idling? Is it smooth/quiet/clean? Or is the idle rough, or do you see some smoke? When it dies, can you start it back up immediately, or do you have to wait and let the electric pump run for a while first?
__________________
86 745 D24T/ZF 345k lifted 2.5"
83 764 D24T/M46 155k

Last edited by v8volvo; 07-15-2015 at 07:27 AM.
Reply With Quote
  #5  
Old 07-16-2015, 07:00 AM
FJ40Jim FJ40Jim is offline
Junior Member
 
Join Date: Sep 2010
Location: Ohio, USA
Vehicle: 745 TD
Posts: 14
Default

Absolutely, the governor will not cause it to die. I was thinking just in terms of "idles but won't rev up".

Fuel restriction and/or air leakage in supply line is the #1 thing to investigate.
__________________
Thanks,
Jim C.
1985 745 TD MT (project)
1986 A2 Golf GTDI swap LeMons racer (very not stock)
2001 Golf TDI (not stock)
Reply With Quote
  #6  
Old 07-25-2015, 10:07 AM
jbadberg jbadberg is offline
Junior Member
 
Join Date: Dec 2013
Location: Cook, NE
Posts: 22
Default

Also chech for return fuel. If the pump has restriction it will run until
Case pressure will cause the pump to not let the plungers move correctly
Some pumps have a check valve to hold fuel in the pump. And it plugs
With small pieces of the governor ring coming apart
Reply With Quote
  #7  
Old 08-26-2015, 06:15 AM
R.Mojica R.Mojica is offline
Senior Member
 
Join Date: May 2013
Location: Rockland county, NY
Vehicle: 85 745 D24Tic M46
Posts: 190
Default

nobody is thinking a clogged fuel filter could be the issue here? Or at least partly.
__________________
99 Ram 2500 24V Cummins 199k
85 745 TD M46 170k (silver)
85 745 TD M46 251k (white) Holset HY35, 4" turbo back, n/a intake manifold, intercooled, GTD nozzles set to 2400psi @18psi. super pumped
86 745 TD auto 254k sold
Several other current gasser Volvos.
67 122S 72k (barn find)
89 760 TIC for sale non running.
93 850 5spd 396K.
94 850 Turbo (race car) 12.55@112.4
95 850 T-5R wagon yellow 199k
04 V70R Titanium/Atacama M66 245k
04 S60 2.5T awd 255k
06 XC90 V8 305k
Reply With Quote
  #8  
Old 08-26-2015, 08:15 AM
ngoma ngoma is offline
Supporting Member
 
Join Date: Nov 2009
Posts: 1,351
Default

Quote:
Originally Posted by R.Mojica View Post
nobody is thinking a clogged fuel filter could be the issue here? Or at least partly.
Of course! Reread post #2 above.
__________________
1985 744 gle d24t
1985 745 gle d24t
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -8. The time now is 07:49 AM.


Powered by vBulletin® Version 3.8.10
Copyright ©2000 - 2024, vBulletin Solutions, Inc.