Quote:
Originally Posted by v8volvo
Are you working on a sedan or a wagon? I have a 740 wagon parts car that I will be pulling the motor from, and then scrapping, within the next month. If the section of floorpan you need to replace is not large, I could almost even cut it out of the bottom of my non-rusty wagon and send it to you.
|
v8volvo,
I have a sedan. The section(s) that need replacement are located in the passenger side (left hand drive) wheel well. Where the wheel well is a vertical sheet of metal making up part of the firewall / door post. I hope I am explaining this clear enough. I need a section starting at this vertical piece and ending where it curves down under to form part of the floor pan. I'll try and get a few pictures tomorrow for a reference. My though if going used was to borrow a cordless Saw Zall and cut the piece out of a junkyard car and have a buddy help me weld it in.