Quote:
Originally Posted by jbg
michaelovitch,
What are you planning to do to lighten the rods? I suppose the idea is to remove some material from each one? Are you planning on balancing the entire rotating assembly?
Excellent work, and thank you for sharing. I saw a few of your videos on Youtube, well done.
|
Thanks for your compliments.
I try to share because those engines are so cool and not enough loved
it motivate too !
About the conrods : i will remove material from the cap and from the pin bushing part (i don't know the name)
But i will make the oil reserve bigger first and remove aroud.
i will try to soften or remove the typical vein of the forging process and a bit of polishing.
i will balance all of them of course and give them the same weight
I don't know if the machine shop in town make the dynamic balancing i will have to see that following the wallet capabilities....
a set of main bearings is 250 euros yet + condors bearings 150 euros +gaskets etc....
i need a bore gauge to see if the block is really still good first