View Single Post
  #3  
Old 06-02-2017, 08:33 AM
718Pinz 718Pinz is offline
Junior Member
 
Join Date: Jan 2015
Posts: 27
Default

I am pulling the vacuum off the back of the intake. We smoked the entire intake yesterday and found a small leak on a weld in one of the intake pipes just before the intake manifold. The silicone is good quality and pretty small runs in between hard pipes. I am running 3" into the turbo and 2.5" from the outlet to the intake, which is a very short run.

These problems have been there since it went back together. There is nothing obvious jumping out at me about this. I even took the air filter out of the box, just in case that was a restriction.
Reply With Quote