Quote:
Originally Posted by adamdrives
Finally using a prybar, I was able to gently rock the pump against the block, and it moved.
|
Not a good way to time the IP. Good possibility of cracking the high pressure injector hardlines, or pre-stressing them for future breakage. If you must rotate the IP, loosen all the hardlines first, then retighten them afterwards, not too tight (16 ft-lbs? Check the forum or greenbook for exact spec) to not deform the fittings.
This post has a better method of timing the IP. There are others here on the forum. We need to make a sticky for IP timing.
http://www.d24t.com/showpost.php?p=6253&postcount=16