View Single Post
  #5  
Old 10-25-2017, 05:54 AM
neilsontom3000 neilsontom3000 is offline
Junior Member
 
Join Date: Feb 2017
Posts: 13
Thumbs up

Quote:
Originally Posted by ngoma View Post
Female spade connector on the brown wire that runs to the GP relay connects to the temperature sensor at the rear of the head. It slides onto the round disc standing off the end of the sensor, just slides on perpendicularly. It provides input to the GP relay logic, to determine whether to energize the GPs at start or not.

The other water temp. sensor, near the front of the head by #1 GP is for the instrument panel temp. gauge.

Attached photos of the rear bussbar. The bends allow it to thread thru the IP mounting bracket. The #6 GP connection is slotted open to ease removal/install. The small nut on the GP terminal just needs to be loosened, not entirely removed (and lost!).

http://d24t.com/attachment.php?attac...1&d=1508869984

http://d24t.com/attachment.php?attac...1&d=1508870006
Thanks Ngoma,

I'd never have thought that connector fitted onto that sensor end unless i'd put the head on first and seen nowt else to try it on!

I offered up the head minus manifold to the block, unfortunately plug 6 fouls the pump, so need to decide weather to move the pump, or go with skint knuckles and swearing getting the plug and lead on afterwards haha!

Cheers.
Reply With Quote