Thread: d24t overhaul+mods
View Single Post
  #20  
Old 05-11-2018, 10:17 AM
volvo_d24t volvo_d24t is offline
Member
  
Join Date: Oct 2017
Location: Canada
Vehicle: 1985 Volvo 745
Posts: 32
Default
Quote:
Originally Posted by ngoma View Post
Is the mating surface ready for a MLS head gasket? It looks smooth enough in the photos! What did it cost?
Yes the surface will be ready for a MLS gasket. it cost me a lot ... it's a old stock that was on display at a shop in Europe. I don't think AMC produce this cylinder head anymore... they seem very good quality. I will get new valves, stem seal and buckets (lifters).

I pulled the crankshaft out of the block and got the parts ready to be cleaned in a washing machine. Next step, the machinist will measure the bore, and then I'll order the right oversize piston set. The main bearings seem good to re-use..

There was 2 broken oil squirter for the pistons

















Last edited by volvo_d24t; 05-11-2018 at 10:20 AM.
Reply With Quote