Okay. Finally tooked my photos.
So i did it like this.
First i unmounted frontbumber, and after that it looked like that.
Then i made rack to IC, and assembled IC there ( note i made it stronger later, rack i mean)
Then bumber back. I had to cut that extra plastic in back of spoiler,
where the three holes are. You know what i mean if you unmount it.
Well, after it, it looks nice.
I will make cover for that IC later, so rocks dont hit it straight.
Then was turn for piping. First, i changed intake manifold from TD one to N/A one. And tig-welded the hole on back of it.
No rubber shit needed anymore. Then i turned cold side of turbo 180* degrees, so at the start points towards land. From there i get piping easily to IC by making 90* degree curve towards IC, and again on IC, 90* degree curve to connect it into it. Okay. Half of the job done.
If you want to make like me, you need to get rid of that visco,
otherwise it dont fit. So, 90* degree curve towards back of the car straight from IC with silicon curve. Then 90*degree curve again, and head of that pipe will come out in motor bay. Then little less than half meter straight pipe,
in angle of about 45* degrees. Then, connect big, aluminium/metal 90* degree piece to that pipe, and with silicon which grows from 2,5" to 3",
to IC. All that looks like this.
Thats it. Grats, youve done your IC project. By the way, you need to cut piece of that sound-dumber cover under bonnet, at bonnet will close.
Ill have some pressure leakage somewhere near turbo at this moment,
and my dumb valve is broken. Some little more to do, but project is mostly done. Tooked about ~550$ from me, whole project, but by knowing what to buy, you will save 100$ from that amount. I suggest to do it that way, its
pretty easy and pretty cool looking. Feel free to ask if need to know something about assembly. Ill update when i get my pressure leak fixed and new/used dumbvalve assembled and buyed.