Thread: d24t parts
View Single Post
  #8  
Old 04-27-2017, 04:30 AM
adamdrives adamdrives is offline
Supporting Member
 
Join Date: Feb 2016
Location: Hudson Valley NY
Vehicle: 1985 744 D24T M46
Posts: 147
Default

Quote:
Originally Posted by v8volvo View Post

Have a few of these but I would have to dig for them which would take a while. In the meantime, if the switch is broken off the body which is common, you can jumper the two wires together, I sometimes do this and remove the switch completely, along with the EGR control relay next to it on that bracket, and get rid of the whole bracket to clean it up. With some additional static timing advance the function doesn't help and if it fails you get excessive advance and resulting problems. Sometimes easiest to can the whole system unless you're trying to keep it factory original. If so, all yours.
I think I will try jumpering the wires. The switch seems to be right where I rest my elbow doing any work on the pump, poor thing has taken a beating.

I was able to properly adjust the throttle and it has picked up some responsiveness on the low end. Having the throttle stop on the fast idle screw is key, if not you're never opening the pump all the way. Thanks for that post.
__________________
1985 744 D24T M46 49mm t3 @20psi 280k
Reply With Quote