View Single Post
  #14  
Old 09-20-2013, 10:05 AM
anders anders is offline
Supporting Member
 
Join Date: Jul 2010
Location: NW Washington USA
Posts: 831
Default

You need to be careful with the injectors, you don't want to get any debris inside of them, if your soaking them its likely that you will get dirt into them. At this point I would disassemble each one individually and clean them thoroughly with brake clean, re assemble and hope the injector bodies won't leak.

You can always have a shop pop test them for you. Before getting them pop tested I would look at the face of the injector nozzle where it seats with the heat shield, if you can see some erosion around the pintle, I would rebuild them.

There are a few members here that would gladly pop test them for you for free if you pay for shipping.

I have four never used rebuilt d24 injectors I can sell you ( you would need to get two more) I also have a set of six low mile rebuilt units that tested good also.
__________________
12mm pump heads, ARP stud kits and GTD nozzles available! http://d24t.com/showthread.php?t=1646
NA intake manifolds and 240 turbo pans for sale.
Need d24 or d24t parts? PM me!
Shipments done on fridays!

1982 242 D24+T/M46- Super pumped! Build thread:
http://www.d24t.com/showthread.php?t=1545
1984 764 D24T/ZF build thread: http://www.d24t.com/showthread.php?t=1734
Diesel parts cars: 82 244,83 244, 84 244, 84 245, 85 745
Reply With Quote