Quote:
Originally Posted by morgan1227
I dont see how I can fit a big torque wrench anywhere..
|
This is where D24 Special Tools come in handy. You need the 17mm - 1/2" square drive dogleg wrench!
Offset 17mm.jpg
It hugs the rear of the IP pulley then bends toward the front, clearing the firewall. Torque wrench can insert from the front.
See sticky
D24 Special Tools for reference.
Quote:
Originally Posted by morgan1227
I didn't see a way to install the bracket bolts to the block once the pump was attached.
|
I did this once from below, after removing the fuel filter housing. A little tricky getting the bolt started but not too bad overall!