You need to be careful with the injectors, you don't want to get any debris inside of them, if your soaking them its likely that you will get dirt into them. At this point I would disassemble each one individually and clean them thoroughly with brake clean, re assemble and hope the injector bodies won't leak.
You can always have a shop pop test them for you. Before getting them pop tested I would look at the face of the injector nozzle where it seats with the heat shield, if you can see some erosion around the pintle, I would rebuild them.
There are a few members here that would gladly pop test them for you for free if you pay for shipping.
I have four never used rebuilt d24 injectors I can sell you ( you would need to get two more) I also have a set of six low mile rebuilt units that tested good also.
|