The more i hunt the more desperate i become.
I can make the timing pin for the pump myself as it seems like a 15.4mm x 35mm shaft. But the rest i am struggling for.
What is the absolute minimum needed for timing belt set up to correct spec? I keep been told to mark up and go for it by volvo specialists here, but that will not guarantee a correct factory set up to start improving from.
And injection pump belt and timing
Again what is the bare minimum needed for set up? Clock with correct sleeve, rear pulley locking pin and?
Is there any drawings out there people have seen or current sources i could order from?
This is a urgent job no doubt for any new owner and we all need sources of info and tools to keep them going. Most of the green book and other links on the D24 are also dead i found personally.
I could arrange a batch run in the UK easily enough if i could get some sizes to produce drawings from
Last edited by ukvolvo; 02-28-2021 at 06:07 AM.
|