The prechamber wasn't "loose" as it still required a punch to tap it out and there was no visible mark on the piston, nor was the gasket deformed from any prechamber movement. See the photos for the extent of the crack. It does not extend into the exhaust port. I think I'll save this head for future welding and machining work. There's a guy here who welded and machined a prechamber:
http://picasaweb.google.com/itzdshtz...15251611814002. You can tell from his blog that he has the welding and machining equipment to do the work, but at least there's proof it has been done with good results. I also have a 2.0TD that had the cracks between the valves welded and machined, it was done before I purchased the head, but again, at least I know it was done.
Considering the rarity of the head and the fact that it isn't warped I'll put it on my shelf. See the next post for the ripped off cam bearing cap base.
From the prechamber side:
From the exhaust port side: