IP
Thanks for the replies, and sorry for the delay! I have a tendency to check out for a while.
I have not reinstalled the pump yet. I have a call in trying to find a part number for the 12mm head. Anyone have a number for such a pump?
I have been careful to make sure to set TDC with the notch on the pulley. I will be sure to pay extra attention to the pump settings when I do put it back together. I did wonder if part of the problem could have been that the timing got off somehow. It should be a bit easier having just been rebuilt.
As for the manifold, I am using the original D24T intake. I welded the original inlet closed, cut off the over-pressure valve and then opened the hole to accept a 2.5” piece of tube and welded that on for the new inlet. I did check that whole setup for any leaks and there were none. I have a Turbonetics Boost Controller for setting the WG pressure.
Phil
|