D24T.com  

Go Back   D24T.com > Search Forums

Showing results 1 to 25 of 500
Search took 0.04 seconds.
Search: Posts Made By: ngoma
Forum: Diesel Engine and Drivetrain Yesterday, 09:09 PM
Replies: 1
Views: 53
Posted By ngoma
The main difference I can think of is the...

The main difference I can think of is the Auto-transmission pump has an emergency fuel shutoff manual lever on the side, to be used in a runaway situation where the auto trans will not let you kill...
Forum: Diesel Engine and Drivetrain 08-10-2018, 10:00 PM
Replies: 1
Views: 55
Posted By ngoma
I removed mine by unbolting at the differential...

I removed mine by unbolting at the differential and the transmission output flanges, and unbolting the center support bracket to the underside and took out the whole driveshaft that way. Make sure to...
Forum: Help! My car died! 08-08-2018, 10:07 AM
Replies: 10
Views: 200
Posted By ngoma
Nozzle centered in the inj. housing is fairly...

Nozzle centered in the inj. housing is fairly important. Bosch even has a centering tool (basically a thinwall metal tube that slides into the gap between the nozzle and the housing) for use when...
Forum: Help! My car died! 08-07-2018, 10:43 AM
Replies: 10
Views: 200
Posted By ngoma
Very good suggestion, will help you pinpoint...

Very good suggestion, will help you pinpoint better where the sound is coming from. You can also compare the sounds on the exhaust side, from each exh. manifold exit.
Forum: Diesel Engine and Drivetrain 08-07-2018, 10:39 AM
Replies: 5
Views: 96
Posted By ngoma
The upper hose carries the hot coolant from the...

The upper hose carries the hot coolant from the engine to the radiator.
Forum: Diesel Engine and Drivetrain 07-29-2018, 09:42 PM
Replies: 6
Views: 313
Posted By ngoma
Cliff's Notes

Cliff's Notes: Small, almost imperceptible leaks at the injector return lines can and do cause performance and starting problems.
Forum: Diesel Engine and Drivetrain 07-29-2018, 09:40 PM
Replies: 3
Views: 149
Posted By ngoma
Are you asking if the GPs are made for a 12VDC...

Are you asking if the GPs are made for a 12VDC system? Yes they are made for a 12V system but you will probably measure closer to 11V at the GPs while energizing them because of the resistance losses...
Forum: Suspension and Brakes 07-25-2018, 10:39 AM
Replies: 10
Views: 8,660
Posted By ngoma
We haven't seen from Slobodan for quite some time...

We haven't seen from Slobodan for quite some time so it is probably on us to carry on ourselves. I would think an accumulator is required, yes.
Forum: Diesel Engine and Drivetrain 07-22-2018, 10:10 PM
Replies: 5
Views: 218
Posted By ngoma
9 times out of 10 it's the small o-ring...

9 times out of 10 it's the small o-ring deteriorated in the brake pedal air switch. Why not check that first? Hook up your mityvac to the small hose that runs to the brake pedal air switch and see if...
Forum: Diesel Engine and Drivetrain 07-21-2018, 12:22 PM
Replies: 5
Views: 207
Posted By ngoma
So your orig. turbo needs rebuilding?

So your orig. turbo needs rebuilding?
Forum: Diesel Engine and Drivetrain 07-21-2018, 12:19 PM
Replies: 5
Views: 218
Posted By ngoma
Removing the entire EGR system will tidy up the...

Removing the entire EGR system will tidy up the area quite nicely, with no ill effects. This includes the microswitches on the IP throttle lever, the vac lines running out along the firewall to the...
Forum: Diesel Engine and Drivetrain 07-19-2018, 09:01 PM
Replies: 14
Views: 1,000
Posted By ngoma
I'm remembering a way to avoid having to...

I'm remembering a way to avoid having to remove/replace that tremendously high-torque crankshaft center bolt:::::::::::::::::::::::::::::::::

Can't you remove the crankshaft pulleys (dampner) via...
Forum: Diesel Engine and Drivetrain 07-17-2018, 11:19 PM
Replies: 14
Views: 1,000
Posted By ngoma
Apparently the dial gauge extension housing has a...

Apparently the dial gauge extension housing has a second extension that, when assembled together provides enough length to attach a dial gauge forward of the vacuum pump. Otherwise, you will need to...
Forum: Diesel Engine and Drivetrain 07-16-2018, 09:12 PM
Replies: 6
Views: 313
Posted By ngoma
Glad you found the problem! I was going to...

Glad you found the problem!

I was going to list the fuel filter as a prime suspect but you had mentioned in your OP that that couldn't be it...
Forum: Performance and aftermarket 06-28-2018, 01:06 PM
Replies: 5
Views: 236
Posted By ngoma
The microswitch I was talking about was the one...

The microswitch I was talking about was the one on the throttle arm bracketry.
Forum: Performance and aftermarket 06-25-2018, 08:59 PM
Replies: 5
Views: 236
Posted By ngoma
Not familiar with the D24tic EGR plumbing, but I...

Not familiar with the D24tic EGR plumbing, but I removed all the EGR pieces from my D24t. All the narrow vacuum line and microswitch pieces were easy, then made two crude blockoff plates for the...
Forum: Diesel Engine and Drivetrain 06-25-2018, 08:54 PM
Replies: 6
Views: 313
Posted By ngoma
Which gasket? The thin square one? Usually those...

Which gasket? The thin square one? Usually those can be carefully cleaned up and reused.

Why do you say it can't be fuel supply or IP issue?

Could you possibly have left a rag or paper towel in...
Forum: Diesel Engine and Drivetrain 05-17-2018, 09:06 PM
Replies: 14
Views: 1,000
Posted By ngoma
Seems like I answered this question recently. My...

Seems like I answered this question recently. My FLAPS has them, like $13? Maybe yours can order one for you? If not, try Rockauto, they have Contitech brand.

More importantly, where are you...
Forum: Diesel Engine and Drivetrain 05-14-2018, 08:37 PM
Replies: 14
Views: 1,000
Posted By ngoma
Why not this one? Half price the other? ...

Why not this one? Half price the other?
...
Forum: The Garage 05-13-2018, 11:23 PM
Replies: 26
Views: 3,089
Posted By ngoma
Volvo 700/900 Heater Core Replacement...

Volvo 700/900 Heater Core Replacement (https://www.brickboard.com/FAQ/700-900/HeaterCoreReplacement.htm)

Don't forget the long 1/4" drive socket extensions for getting at those hidden screws on...
Forum: The Garage 05-13-2018, 11:33 AM
Replies: 26
Views: 3,089
Posted By ngoma
Interesting. Did you find the remains of the 2...

Interesting. Did you find the remains of the 2 broken oil squirters in the oil pan?
Forum: Diesel Engine and Drivetrain 05-08-2018, 10:53 PM
Replies: 1
Sticky: IP Timing
Views: 3,621
Posted By ngoma
I like this description better

Again, thanks to v8volvo for this explanation of the preferred method of IP timing:

- ensure cold start device is disengaged and rotate the pump a bit afterwards to let the IP timing parts settle...
Forum: Diesel Engine and Drivetrain 05-07-2018, 09:49 PM
Replies: 3
Views: 402
Posted By ngoma
You may need to improvise as I am. Sections of...

You may need to improvise as I am. Sections of 5/8" and 7/8" hose, with brass 90deg. elbow and 7/8 <=> 5/8" reducing coupling. The 5/8" hose connects to the heater core, running downward to the elbow...
Forum: Diesel Engine and Drivetrain 05-07-2018, 11:15 AM
Replies: 2
Views: 363
Posted By ngoma
As you already know, diesels in general will not...

As you already know, diesels in general will not warm up to operating temp. from just starting and idling as a gasoline engine would.

Mine is up to temp within 5 minutes of easy driving from...
Forum: Diesel Engine and Drivetrain 05-06-2018, 08:29 PM
Replies: 4
Views: 539
Posted By ngoma
Perhaps I am not using the best tool choices for...

Perhaps I am not using the best tool choices for removing the valve cover but by the time I would finally be able to get the valve cover off, the engine would be way cooler than operating temp.! And...
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -8. The time now is 10:27 PM.


Powered by vBulletin® Version 3.8.10
Copyright ©2000 - 2018, vBulletin Solutions, Inc.