D24T.com  

Go Back   D24T.com > Search Forums

Showing results 1 to 7 of 7
Search took 0.00 seconds.
Search: Posts Made By: ngoma
Forum: Diesel Engine and Drivetrain 02-07-2018, 07:09 PM
Replies: 13
Views: 15,836
Posted By ngoma
Leave it at TDC. Tighten the crank pulley bolt as...

Leave it at TDC. Tighten the crank pulley bolt as best you can, using your pulley counterhold tool in one hand, wrench in the other.

Do a camshaft timing while at TDC. Tighten the camshaft pulley...
Forum: Diesel Engine and Drivetrain 02-07-2018, 11:17 AM
Replies: 13
Views: 15,836
Posted By ngoma
Yes, they used the same pulley for the two...

Yes, they used the same pulley for the two positions. The notch and keyway relief do nothing in the camshaft rear position.


Just realize that a torque wrench is not very accurate near the ends...
Forum: Diesel Engine and Drivetrain 02-06-2018, 12:53 PM
Replies: 13
Views: 15,836
Posted By ngoma
We don't use the IP lock pin for setting the...

We don't use the IP lock pin for setting the timing. The IP cogged pulley is keyed to the shaft and has a small groove in its outer edge that coincides with the fine straight mark on the IP body...
Forum: Diesel Engine and Drivetrain 12-22-2017, 07:58 PM
Replies: 13
Views: 15,836
Posted By ngoma
How did it all work out, neilsontom3000?

How did it all work out, neilsontom3000?
Forum: Diesel Engine and Drivetrain 10-25-2017, 09:46 AM
Replies: 13
Views: 15,836
Posted By ngoma
You'll probably like it better to remove GP #6...

You'll probably like it better to remove GP #6 before refitting the head, and reinstall GP #6 afterward. Some like to lay a board over the engine compartment and attack it from the other side.
Forum: Diesel Engine and Drivetrain 10-24-2017, 10:35 AM
Replies: 13
Views: 15,836
Posted By ngoma
Female spade connector on the brown wire that...

Female spade connector on the brown wire that runs to the GP relay connects to the temperature sensor at the rear of the head. It slides onto the round disc standing off the end of the sensor, just...
Forum: Diesel Engine and Drivetrain 10-23-2017, 09:36 PM
Replies: 13
Views: 15,836
Posted By ngoma
Sorry the (relatively) simple injectors R/R job...

Sorry the (relatively) simple injectors R/R job went south on you. I'm trying to imagine how or what kind of hole punch could be used to pull out the injector heat shields.

Another tool you will...
Showing results 1 to 7 of 7

 
Forum Jump

All times are GMT -8. The time now is 06:19 AM.


Powered by vBulletin® Version 3.8.10
Copyright ©2000 - 2024, vBulletin Solutions, Inc.