D24T.com  

Go Back   D24T.com > Search Forums

Showing results 1 to 10 of 10
Search took 0.00 seconds.
Search: Posts Made By: Slobodan
Forum: Performance and aftermarket 12-31-2016, 11:34 PM
Replies: 19
Views: 26,380
Posted By Slobodan
Mercedes OM616 runs awesomely. but won't embark...

Mercedes OM616 runs awesomely. but won't embark on swap until sunny weather hits.
Forum: Performance and aftermarket 12-19-2016, 05:05 AM
Replies: 19
Views: 26,380
Posted By Slobodan
with all injectors out, pour oil or some...

with all injectors out, pour oil or some concoction of penetrating oil into the cylinder with lowest compression. replace injector on the cylinder you are treating. use ratchet wrench on crank pulley...
Forum: Performance and aftermarket 12-17-2016, 10:55 PM
Replies: 19
Views: 26,380
Posted By Slobodan
Its still got life!!!!! I replaced the...

Its still got life!!!!!
I replaced the starter, and battery, then used two sets of jumper cables.
Took a ton of cranking, and stuff, but it finally cracked off.And its colder tonight than it was...
Forum: Performance and aftermarket 12-17-2016, 03:22 PM
Replies: 19
Views: 26,380
Posted By Slobodan
To be fair, I grabbed this engine out of the...

To be fair, I grabbed this engine out of the junkyard with unknown amount of miles on it. Looked clean, no leaks, Also the block was painted black, somebody was in there at some point. The car it...
Forum: Performance and aftermarket 12-17-2016, 01:54 AM
Replies: 19
Views: 26,380
Posted By Slobodan
Oil: Delvac 1300 15W40 How it ran the day...

Oil: Delvac 1300 15W40
How it ran the day before: It seem to run okay. Not 100% smooth like a nice D24T but with a little wobble to engine. still seemed to hit on all six. I am using a K&N cone...
Forum: Performance and aftermarket 12-13-2016, 09:28 PM
Replies: 19
Views: 26,380
Posted By Slobodan
I have checked glow plugs about 2 months ago, and...

I have checked glow plugs about 2 months ago, and all were working perfectly. they are only 2 years old. Bosch.
Its getting plenty of fuel. Even the ether couldn't get it going. Compression is just...
Forum: Performance and aftermarket 12-12-2016, 04:59 AM
Replies: 19
Views: 26,380
Posted By Slobodan
1800rpms I see 2psi and 10 psi by 2400 and 20 psi...

1800rpms I see 2psi and 10 psi by 2400 and 20 psi by 2800.
However since the cold weather hit, It couldn't be coaxed into starting up. NOT even ether, which is a big no no. but I was desperate to...
Forum: Performance and aftermarket 12-01-2016, 10:14 PM
Replies: 19
Views: 26,380
Posted By Slobodan
Its been almost 9 months, been running it at...

Its been almost 9 months, been running it at 20+psi
I slapped on another KKK K24 turbine with K26 compressor.
MUCH Better!, boost hits much better. I dialed fuel back for time being, still very...
Forum: Performance and aftermarket 03-16-2016, 06:33 AM
Replies: 19
Views: 26,380
Posted By Slobodan
so far boost comes on a little later, by 2000...

so far boost comes on a little later, by 2000 rpms making 2 - 3 psi and 2500 making 10psi. Feels like it develops more torque through out the revs. Engine even sounds more radical from exhaust. 2.5"...
Forum: Performance and aftermarket 03-15-2016, 08:51 PM
Replies: 19
Views: 26,380
Posted By Slobodan
KKK K24 From MErcedes DOES fit D24T

Yes, It fits no problem. Just had to make an oil line for the feed.
KKK power.
Showing results 1 to 10 of 10

 
Forum Jump

All times are GMT -8. The time now is 06:51 AM.


Powered by vBulletin® Version 3.8.10
Copyright ©2000 - 2024, vBulletin Solutions, Inc.