D24T.com  

Go Back   D24T.com > Search Forums

Showing results 1 to 6 of 6
Search took 0.00 seconds.
Search: Posts Made By: adamdrives
Forum: Items Wanted 04-27-2017, 04:30 AM
Replies: 9
Views: 12,435
Posted By adamdrives
I think I will try jumpering the wires. The...

I think I will try jumpering the wires. The switch seems to be right where I rest my elbow doing any work on the pump, poor thing has taken a beating.

I was able to properly adjust the throttle...
Forum: Items Wanted 04-17-2017, 02:53 PM
Replies: 9
Views: 12,435
Posted By adamdrives
Thanks for that explanation. I will have to give...

Thanks for that explanation. I will have to give it a shot again as the stops on the spool are acting as the rev limiter and idle stops, but after going through the procedure a few times I now have a...
Forum: Items Wanted 04-16-2017, 06:58 AM
Replies: 9
Views: 12,435
Posted By adamdrives
Yes, that is the greenbook procedure I was...

Yes, that is the greenbook procedure I was referring to. Do you think it's still possible to set correctly when the cable cannot be made taught (step 1)

I will have to try again. Difficult to wrap...
Forum: Items Wanted 03-23-2017, 06:27 AM
Replies: 9
Views: 12,435
Posted By adamdrives
Thanks for the reply. The first step in adjusting...

Thanks for the reply. The first step in adjusting the throttle afaik is to tighten the cable up until there is no slack. I did mess with the ball stud to try to get full travel of the throttle arm so...
Forum: Items Wanted 03-20-2017, 06:55 PM
Replies: 9
Views: 12,435
Posted By adamdrives
Thanks Thanks for the reply. I was...

Thanks



Thanks for the reply. I was under the impression the auto and manual spools were different, I guess I have the CC unit. I believe it does have the appropriate bracket on the pump. Mine...
Forum: Items Wanted 03-07-2017, 10:02 PM
Replies: 9
Views: 12,435
Posted By adamdrives
d24t parts

Looking for:
manual throttle spool
cruise control module (or whatever hardware is necessary to make cruise work, I can figure out wiring/relays)
altitude compensation switch (two spade connector...
Showing results 1 to 6 of 6

 
Forum Jump

All times are GMT -8. The time now is 12:03 AM.


Powered by vBulletin® Version 3.8.10
Copyright ©2000 - 2024, vBulletin Solutions, Inc.