Recieved Four D24T engine blocks
 

I picked 'em up for NOTHING.
One block has a crank.
One block has squirters.
The other two are completely bare.

I've got four dead D24's so theres good cranks, rods, bearings and everything else to build some fresh D24T's except I need some D24T Pistons, 3 sets of squirters and a couple of Turbo Exhaust manifolds.

I can barely get a hold of pistons from IMC maybe not anymore... but last I checked there was a set of 2nd OS. @ 97$ per piston. Mahle.

Does anyone have a way of getting / sourcing some of theses parts? (D24T pistons + rings, and Squirters?)

Last time I checked IMC had pistons and rings. I have never seen oil squirters listed anywhere. You might try over on the VWdiesel.net site and see if anyone has any laying around. I would expect they are the same as a 1.6 turbo diesel.

Your shop buy through IMC I take it? We get stuff from them too.

Jason

yeah, IMC is 15 miles away.. but they deliver. WorldPac is just 4 blocks up from my shop. but they don't carry much D24 stuffs.

Pistons, rods, squirters, valves, rings, etc are all identical to what is in a VW 1.6TD engine, as used up through 1992. Should be easy enough to find.

I ordered some 1.6D (don't remember if it was turbo or non) rod bearings and they ended up being smaller than the D24's.

Maybe something else happened. but I thought it would have worked.

Little help to your problem from europe.
Oil squirters from Volkswagen 1.8 16v (KR/PL)-block should fit to d24t block,
and they sell still new ones, oil squirters i mean.

Something must have gotten boxed wrong, as they should be the same.

Jason

The VW diesel engine family is fully modular and all the internals are identical. If the stuff you got didn't fit then it was the wrong stuff.

Thanks for the tip about the squirters -- would be hard to get em otherwise!

FCP Groton has Kolbenschmidt pistons for these engines. Bought a set of 'em last year.

Its my understanding that the D24T pistons have the squirter cutout in a different place than the 4 cyl engines. I believe you can get pistons with both cutouts in them but you may want to check on that point.

Steve